The pipe cap is welded in the direction of the pip

The pipe cap is welded in the direction of the pipe

The pipe cap is generally used at the sampling port not at the end of the pipe. After the sampling is completed, the pipe cap should be screwed on. Second, in special circumstances, after the pipe cap is screwed off, the pipe can be connected to the wire port for temporary continuous feeding or pumping. With the tube cap in the case of low pressure, easy to disassemble and repair, high pressure in general do not need to tube cap. Used to close the pipeline, the function is the same as the pipe blocking. Features 1, health: This product is a green building material, can be used for pure drinking water piping system. 2. Heat resistance: under the specified long-term continuous working pressure, the water temperature of the pipeline can reach 95℃. 3, corrosion resistance, no scaling: can avoid the pipeline scaling blockage and basin, bathtub yellow rust worry. 4. Heat preservation and energy saving: thermal conductivity is metal.

The storage of the pipe cap is more fitting, which affects the use and installation of the pipe cap.

When splicing, the weld direction is only allowed to be radial and circular. Large caps may remove this requirement in the future. The splicing distance should be greater than 3δ and not less than 100mm. (The welding heat affected zone is a high stress zone, and the chemical composition in the zone will be burned. So avoid the high stress zone, which is related to thickness. According to practical experience, the stress reduction length is greater than 3δ and not less than 100mm). However, when using tube and cap products, it is necessary to follow the requirements and instructions for installation and operation.

• 上一篇：Knowledge of stainless steel tube caps

• 下一篇：To create satisfactory carbon steel pipe caps for