Pipe cap manufacturers direct sales

Pipe cap manufacturers direct sales  

 Pipe cap manufacturers mainly produce various types and materials of pipe cap, elbow, tee, size head, flange, elbow and so on.  Welcome the presence of new and old customers.  

 Pipe caps are mainly used for one end of pipe and are welded to the outer thread of pipe end to cover and block pipe fittings.  Used to seal the pipe, does not work in the same way as pipe blocking.  The type blind is similar in form, except that the blind is detachable and blocked, while the welded pipe cap is not detachable.  Tube cap is also known as head, cone shell, plug, etc.  

 If the tube cap manufacturer requires that the forming thickness of the tube cap shall not be less than the nominal thickness δ N minus plate negative deviation C1, then the feeding thickness δ S =δ N +C1+C3+△2=8+0+1.5+0.5=10mm, and the small thickness after forming is 8.5mm.  If the tube cap forming thickness is not less than the design thickness δ D (the value of δ E should be taken), the feeding thickness: δ S =δ D (δ E) +C3+△2=8mm, and the small thickness after forming is 6.5mm, which is larger than the effective thickness δ E, larger than the design thickness δ D and the calculated thickness δ D.  Cap manufacturers can see from the above, the two different requirements, so that the cap feeding thickness of 2mm difference, and weight difference of 300kg.  The thickness definition of tube cap manufacturer GB150 and related tube cap standard is not reasonable, which is mainly reflected in the thickness requirement of container and tube cap after forming. The forming thickness requirement of convex tube cap and hot drum should not be less than the negative deviation of nominal thickness minus steel plate (δ N-C1).  

 Cap manufacturers, 16Mn tube cap has put forward the concept of small forming thickness: 16Mn tube cap "hot coil cylinder or convex tube cap after processing to ensure the thickness, its value is not less than the design thickness".  The manufacturer of 16Mn pipe cap, that is, the designer should mark the nominal thickness and small forming thickness (i.e. design thickness δ D) on the drawing, so that the manufacturing unit can decide whether to add the reduced 16Mn pipe cap according to the manufacturing process and the original design rounding amount.  

 Pipe cap manufacturers mainly according to customer requirements production forming, welcome customers to consult order!