Protection of various pipe cap sizes

Protection of various pipe cap sizes  

When the cap is provided to the customer, it is necessary to briefly introduce the protection and safety technology of the cap products for the customer.  Pipe cap, also known as head, plug, cover, pipe cover, head, welded at the pipe end or installed on the pipe end of the outer thread cover blocked pipe fitting, used to close the pipe, the same effect on the pipe plug.

Type analysis of pipe cap: the form of blind plate is similar, except that the blind plate can be detachable and blocked, while the welded pipe cap can not be detachable.  The pipe cap includes convex pipe cap, cone shell, reducer section, flat cover and the design of tightening mouth.

Convex pipe cap includes: hemispherical pipe cap, oval pipe cap, disc pipe cap and dome pipe cap.  From the point of view of force, convex pipe cap is gradually bad from the hemispherical pipe cap, but from the point of view of manufacturing difficulty, gradually good manufacturing.

Weld direction is only allowed to be radial and circumferential.  This requirement may be removed for larger caps in the future.  The splicing distance should be greater than 3δ and not less than 100mm (the weld heat affected zone is a high stress zone, and there will be burning loss of chemical composition in this zone.  So avoid areas of high stress, which are related to thickness.  According to practical experience, the stress attenuation length is greater than 3δ and not less than 100mm).  But refrigeration equipment is difficult to meet this requirement, has its particularity.

 The company mainly produces all kinds of different specifications and materials of pipe cap, elbow, tee, size head, flange, steel pipe and so on.  Welcome the customer consultation order!