Experienced and strong strength of reducer manufac

Experienced and strong strength of reducer manufacturers

The company mainly produces a variety of different materials and different types of reducer, our company through advanced technology and equipment to produce concentric reducer and eccentric reducer of different types of reducer.

Both concentric reducer and eccentric reducer are used in pipe installation for sizing, sizing and manufacturing of different sizes of sizing reducers according to customer requirements.Such reducer can be used in petroleum installation according to economic development and requirements. Such reducer can be corrosion-resistant in pipeline after many years of use. It can be directly welded and flanged during installation.The difference between the eccentric reducer and the concentric reducer: The eccentric reducer whose dots are not on the same line is called the eccentric reducer.The dots in the middle are called concentric reducer.The use of eccentric reducer and concentric reducer is different. Eccentric reducer and concentric reducer should be used in the following cases. It is necessary to avoid the use of bottom flat for the horizontal pipe of liquid where liquid accumulates.

The company has an experienced research team, as well as a strong scientific and technological force, trap production equipment and inspection and testing equipment, with a very comprehensive design and manufacturing conditions.reducer material is mainly divided into;Carbon steel, alloy steel, stainless steel, etc.reducer model is based on the customer's needs directly manufactured.

Our company through many years of production experience to obtain domestic and foreign customers to visit the factory and order.

Conclusion and theory of reducer

In the process of using reducer, the main conclusion is that the velocity isoline is sparse in the inlet section, and the velocity at the symmetric position does not change much. The higher the section position is, the greater the velocity change will be, and the same velocity isoline shrinks inward.The water content on the same symmetric surface is almost the same. The water content decreases first and then increases in the small pipe segment near the wall.There is approximately no shear stress at the entrance of the large pipe section. Corrosion resistant steel or appropriate wall thickness should be adopted.

Pipeline leakage is caused by corrosion of reducers in use, which leads to the loss of a large amount of energy and serious environmental pollution, posing potential hazards to the stable operation of the society and the environment.The Suggestions are as follows: the flow in the tube of reducer is obtained, and the anti-corrosion in the microtopographic map provides a certain theoretical basis for the operation and maintenance of the pipeline.

305307